advicezopa.blogg.se

You can now specify an IPv6 address for the VXLAN VTEP interface. New/modified commands: show management-interface New/modified screens: Devices > Device Management > Interfaces Routing table if you do not specify interfaces. Use separate Platform Settings policies for merged andĭNS lookups no longer fall back to the management-only Specify the diagnostic interface by name, then you must If Platform Settings for syslog servers or SNMP hosts You can no longer enable HTTP, ICMP, or SMTP forįor SNMP, you can allow hosts on management instead ofįor Syslog servers, you can reach them on management If you specify the management-only interface (including The management-only routing table can now only be used Only the merged management interface isīehavior of AAA traffic to use the data routing table byĭefault. Management Center Using the Serial Number (Low-Touchįor new devices using 7.4 and later, you cannot use the legacyĭiagnostic interface. Supported platforms: Firepower 1000/2100 and Secure Firewall Reachable): 7.2.4, with support temporarily deprecated in 7.3 Minimum threat defense (management center is not publicly Minimum threat defense (management center is publicly New/modified screens: Devices > Device Management > Add > Device > Serial Number With SecureX and Cisco Defense Orchestrator for this Management center by serial number without having to perform any Low-touch provisioning lets you register devices to the Previously, this feature was supported only on the Firepower

Settings policy now apply to the Secure Firewall 4200. The performance profile settings available in the platform

These devices support the following new netmods:Ģ-port 100G QSFP+ network module (FPR4K-XNM-2X100G) We introduced the Secure Firewall 4215, 4225, and 4245.